Since 02/16 when we had some near 0F winter weather and more than a week
of winter storm, I have not heard my powerline arc RFI at all. I am
retired and here everyday. So guess I should be happy it left on its
own. But I doubt its gone for good....It was absent last year from mid
summer until December. Will see.
Never got a chance to use the ultrasonic dish on it before the winter
weather.
https://www.qsl.net/af4o/Powerline%20RFI%20QSL.net%20Webpage/Arc%20Webpage.html
73
Chuck
AF4O
On 1/29/21 5:35 PM, Charles Plunk wrote:
Update;
After logging weather conditions related to the noise. The first few
hours of a rain, I can still hear it although its not as constant.
After that and a good rain it stops. Then it takes >36 hours of rain
free weather for it to return. Lower humidity also makes it return
more in force. Last 3 rains this has happened.
I did something today I have never done before in years past or this
time. Taking advice from one on this excellent reflector. I listened
to the noise on one HT on UHF being re transmitted with mic at my hf
rigs speaker (30 meters, low noise level but strong arc rfi). RF gain
turned down and volume up on hf to maximize the arc noise. Then used
my 145mhz HT on AM and 3 element tape measure beam. Comparing the
noise of both HTs to ensure I had the correct noise, this lead me to
triangulate a different pole. Just triangulating for max noise does
not work. Seems most all the poles have some noise getting within
10-25' of them.
About the time I got the ultrasonic dish out, the noise ceased. Then
when it came back, the volume pot/on/off switch broke on my
ultrasonic. So stopping for the night. And supposed to rain tomorrow.
Oh the pole now suspect is at the corner of my back yard....may go out
tonight and take pictures of it to see if any arc shows up. May get
lucky. Thats if the arc is present. This pole does not have a street
light but does have lightning arrestors also and is 3 phase also up
the line from the other pole. One end of my doublet is less than 20'
from this pole....
Stay tuned.
Chuck
AF4O
On 1/11/21 1:20 PM, Charles Plunk wrote:
Long Story but will try to keep it to my point. I have triangulated
my power line arc to a pole. Fairly typical 3 phase old residential
but busy pole. Insulators, disconnects, lightning arresters, a
transformer, etc. Pole is a junction as the 3 phase goes off in 3
directions from that pole. Arc is not affected by rain. And I cannot
hear it with my ultrasonic dish. In the past I have pinpointed bad
hardware on other poles with the dish.
I suspect the lightning arresters. There are 3 on there, one for each
phase and I assume very little way I could tell which one. Rural
utility, knows little about and/or is not concerned about arc rfi
other than past dealings with me and TVA (power distributor who does
have rfi location capabilities but is rather difficult to get them
out to do).
And now the arc is intermittent. Today its pulsing about every
second. Next week it may get solid for a while or go away entirely.
And of course if TVA comes out, it will be gone.
What hardware, other than lightning arresters (arcing internally)
would not be affected by rain and I could not hear with the dish?
Would it be reasonable enough to ask the util to replace the
lightning arresters before bugging TVA?
Any thoughts appreciated.
Thanks,
Chuck
AF4O
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|