There are two ways to report this to Solar Edge.
The first is to go through your installer. If they confirm that they have
reported it to Solar Edge, then this will be put in a queue to be verified,
then replaced if needed.
You can also send it through ARRL, via Steve Anderson, W1EMI@arrl.org.
Solar Edge will verify the problem by remotely shutting off the system, with
you at your receiver to confirm that the noise went away. They will then
coordinate with the neighbor and installer and arrange to remove the system
from the neighbor's house and replace it, ensuring that good wiring practices
such as twisted pair are used, along with strategically placed ferrite cores.
Ed Hare, W1RFI
ARRL Lab
________________________________
From: RFI <rfi-bounces+w1rfi=arrl.org@contesting.com> on behalf of damichael---
via RFI <rfi@contesting.com>
Sent: Sunday, February 13, 2022 8:31 PM
To: rfi@contesting.com <rfi@contesting.com>
Subject: [RFI] Severe RFI to 630M from Solar Edge HD Wave inverter
Neighbors newly installed Solar Edge HD Wave inverter and solar panel system is
causing severe RFI to 474.5 Khz 24 hours a day. It doesn't even stop after
dark. Its smps RFI drifts around 474.5Khz depending on temperature.
I also have many RFI carriers up to at least 14.3mhz but most seem to stop
after dark.
How do I get corrective action out of Solar Edge?
TNX es 73, Mike W3TS
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|