Hi Jim,
I've had some noise sources which were electronic, but most have been
power line related. Besides the preponderance of 120 Hz harmonics in the
AM audio, the very broadband nature of line noise is usually the main
indicator.
73,
Scott K9MA
On 2/1/2023 2:33 AM, Jim Brown wrote:
On 1/31/2023 9:21 PM, K9MA wrote:
My QTH is in an older residential area, surrounded by overhead power
lines. Line noise is a constant problem. We recently had a major
power outage, so I measured the noise levels to get a baseline with
little line noise.
Hi Scott,
How do you know that it's line noise, not electronic noise? 25 years
ago, line noise was a good assumption for anything we heard on the
bands, but in almost any developed area, the average home has a couple
of dozen electronic sources, everything from switch-mode power
supplies for everything that plugs into the wall, variable speed
controllers for motors, computers and lots of other stuff with
microprocessors in them, and on, and on. When the power goes out, so
do all of those electronic noise sources (except for those that UPSs
keep running).
The slides for talks I've done at Pacificon, Visalia, and to some
clubs, show how to use a well-adjusted waterfall to differentiate
between impulse noise (which is what line noise is) and electronic noise.
http://k9yc.com/KillingReceiveNoise.pdf
Yes, those with ear experience can nearly always tell the difference.
NK7Z has wonderful advice and resources on his site about using 24
hour very wide waterfalls to yield clues about operating hours of both
impulse and electronic sources, and also recognizing multiple
electronic sources.
73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
--
Scott K9MA
k9ma@sdellington.us
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|