[RTTY] FSK and TS940

["tomhomsley@knology.net" <tomhomsley@knology.net>]

I have a Kenwood TS940 I am trying to set up to run FSK.  Software is 
MMTTY.  Hardware is PC COM1 to RigBlaster Pro to ACC2 (13-pin DIN) on rear 
of 940.  Reports say I have a carrier but no diddle?  One report on 
eham/elmer said the Processor-Out had to be adjusted???  Any ideas?
Tom, N4WBS
-- 
Tom Homsley, N4WBS
tomhomsley@knology.net

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty