I am going to by an IC 7000 but here in Europa it is not possible now -
mabye in spring.
I am working with the cocoaModem with my IC 700 and I am using an
SignaLink SL-1+
I have the manual of the IC 7000 and i am sure I can use the IC 7000
like the IC 700 with the same
interface and cable....
The point is that as far I can understand the IC 7000 manual, it can be
fixed in split mode on RX and TX
so it is possible to use AFSK without speciel tuning for QRG change....
That is not possible with the IC 700.
OZ9GA Torben
Den 20/12-2005, kl. 20.23, skrev Dick Kriss, AA5VU:
> Torben,
>
> I missed your point? What's the benefit is you are already using
> cocoaModem
> in AFSK. Surely cocoaModem's decoder is better than the IC-7000
> built-in
> decoder.
>
> What interface are you using between cocoaModem and the IC-7000?
>
> Dick AA5VU
>
> On 12/20/05 11:51 AM, "Torben Kahr" <OZ9GA@dixit.dk> wrote:
>
>> As far as I understand, the IC-7000 is working split in both RX and TX
>> at the same time. That is good if you are working AFSK with
>> cocoaModem.
>> Am I right?
>>
>>
>> Den 20/12-2005, kl. 18.32, skrev Dick Kriss, AA5VU:
>>
>>> I read the FB QRZ review of the IC-7000 and was surprised that it
>>> only
>>> decodes RTTY. What good is a rig with a RTTY decoder only? I don't
>>> see the
>>> need or appreciate the value of a built-in decoder unless the rig
>>> comes
>>> with software for doing something with the data and that will let you
>>> transmit.
>>>
>>> What am I missing on the value of a rig with a built-in RTTY
>>> decoder?
>>>
>>> 73, Dick AA5VU
>>>
>>>
>>> _______________________________________________
>>> RTTY mailing list
>>> RTTY@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/rtty
>>>
>>
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|