Hi Ian,
I don't think anyone directly answered your question. The easiest way to
change profiles is to edit USERPARA.INI. The mark frequency is labeled
"DefMarkFreq=". You can do a search and replace on the USERPARA.INI file by
searching for 2.125 and replacing with 1.275. I assume you know to change
it in the MMTTY setup Ham default on the Demodulator tab.
If you want to do it through the MMTTY menu system you can do this:
1. Make a backup of your MMTTY.ini and USERPARA.INI files
2. Set the MMTTY setup Ham default on the Demodulator tab
3. Select a profile you want to change from the Profiles menu
4. Select the Mark frequency you want in the Demodulator section just under
the View(V) heading
5. If you want, make any other changes to the profile
6. In the Profiles(S) menu select Assign Menu and select the same profile
you loaded in step 3.
7. Either click OK or modify the name to reflect your change and then
select OK.
8. Repeat steps 3 thru 7 for each additional profile you want to change
73 Art W2NRA
"Keep to the Code!"
w2nra.com
----- Original Message -----
From: "Ian White GM3SEK"
>
> Thanks to Dave AA6YQ for hosting the extended set of MMTTY profiles, at:
>
> www.dxlabsuite.com/winwarbler/Profiles/UserPara.ini
>
> I'm trying to edit all of these profiles for a mark frequency of 1275Hz,
> and the only parameter that isn't clear is RXlmsNotch. In the original
> file, this parameter takes various values both above and below the
> default mark frequency of 2125Hz.
>
> Should I simply use the same offsets above and below the new mark
> frequency, or is there a more subtle rationale?
>
> 73 from Ian GM3SEK
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|