> If anyone has any suggestions on how I can get CAT to work with
> WriteLog I would appreciate the help. Thanks in advance
Make sure you have properly configured hardware handshake in WriteLog
and your interface. The TS-570 is one of the most difficult/unreliable
CAT interfaces because the controller is too small/slow for the job.
If handshake is not set properly the TS-570 will "handshake off" and
refuse to respond to the computer.
73,
... Joe, W4TV
On 10/19/2010 7:10 PM, Sidney Grimes wrote:
> HELLO ALL
> I used WriteLog with MMTTY for the first time in the JARTS Contest this past
> weekend. Overall I am very pleased with WriteLog, but I was unable to keep
> the CAT connection up with the transceiver. WriteLog would connect for a
> minute or so and function properly but then it would loose communications
> with the transceiver and show NO RIG. (Not an RFI issue since the problem
> occurs in the receive mode) I had the same problem with MMTTY running alone.
> I was able to solve the problem by setting the polling interval to 2 sec. The
> help file in WriteLog suggests unchecking the poll box if the CAT function
> operates erratically. When I did this I was unable to get the CAT function to
> work at all. The help file says that with the poll box unchecked the software
> will only poll the transceiver when dupe checking. I found the the CAT
> function did not function and the dupe checking was incorrect.
> The setup is a KENWOOD TS570D and a NAVIGATIOR interface. CAT works fine
> when using MixW so the problem is not with the rig or the interface.
> If anyone has any suggestions on how I can get CAT to work with WriteLog I
> would appreciate the help. Thanks in advance
>
> 73
> Sid KK8X
>
>
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|