I am trying to have the Macro send the command to change the focus.
Example
Press F5 - Radio changes tx focus to VFO B , then transmit my call.
The up/down arrows do work, but I cannot find a way to send the down
arrow in a macro, without me actually pressing it.
I hope this is clearer than mud.
Rich
On 1/7/2016 19:33 PM, Ed Muns wrote:
Up/Down arrows.
73,
Ed W0YK
On Jan 7, 2016 4:07 PM, Neal Campbell <nealk3nc@gmail.com> wrote:
I think its the arrow keys that change focus (I could be wrong though..)
Neal Campbell
Abroham Neal LLC
On Thu, Jan 7, 2016 at 7:04 PM, Rich <rwnewbould@comcast.net> wrote:
Folks,
I am using Writelog and looking for some guidance or ideas.
I am trying to create a macro that will change the TX focus to the second
radio in this case VFO B and then send my S&P callsign, F5 in my
particular setup. I cannot find a way to change the TX focus in automated
fashion. I have had a few suggestions from folks, but they do not seem to
work. As far as I can tell none of the % commands will change TX focus.
In short, is there a way to change TX focus via a Function Key command
syntax.
Thanks
Rich
K3RWN
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|