I have also found the Edgeport USB to serial boxes work fine.
73
Jim W7RY
-----Original Message-----
From: Joe Subich, W4TV
Sent: Friday, October 27, 2017 10:06 AM
To: rtty@contesting.com
Subject: Re: [RTTY] Intel NUC, anyone?
Edgeport is the only maker of USB to Serial converters that I know of
that properly support low (45, 50 and 75 baud) data rates. Again, their
converters are microprocessor based with a hardware bit clock. It is
not necessary to use EXTFSK or other software FSK "drivers" with the
Edgeport products.
73,
... Joe, W4TV
On 10/27/2017 10:42 AM, Jim McDonald wrote:
Would an Edgeport USB-to-serial adaptor work?
73, Jim N7US
-----Original Message-----
Hi Peter,
Have you looked into TinyFSK?
http://www.frontiernet.net/~aflowers/tinyfsk/
I was looking into doing something similar as you with either a small form
factor PC, cheap laptop or some other device (which I still have to get).
Realizing that they would not have a serial port for FSK keying, I built
an
interface that included the TinyFSK. It worked very well for me. I used it
with the N1MM logging software for some contesting as well.
73,
--Alex KR1ST
On 2017-10-25 22:31, Peter Laws wrote:
Now my problem is that the NUC has no serial ports.
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|