Jim,
I've not tried that method of keying via the serial port. I did use the
parallel port which was OK most of the time, unlesss I asked the
computer to do some other task. That wan under Win98. Since then I've
been busy building a couple of Winkeyers.
Nick.
W4ATK wrote:
> Nick,
> WinKey is OFF. Experimentation has revealed the following:
> When you press the CTRL key and switch to KEYBOARD mode, DTR is
> asserted.
> If you then type a character on the keyboard, the first dit or dah will
> be
> "lost", then the balance of the first character and all subsequent
> characters will be sent normally.
>
> Once you leave the KEYBOARD mode and later return the cycle repeats itself.
> I suspect the possibility of a bug in that when CTRL is pressed using the
> internal SD keyer DTR should not be asserted (negative), rather it is
> asserted (positive).
>
> Jim W4ATK
>
> -----Original Message-----
> From: Nick G4IRX [mailto:nick.sduser@nowindows.net]
> Sent: Friday, May 09, 2008 2:28 PM
> To: W4ATK
> Subject: Re: [SD-User] Correction....
>
>
> Jim,
>
> Do you have SD in WINKEY mode? check with STATUS command, try toggling
> on and off with WINKEY command. WINKEY uses DTR and RTS to power the the
> keyer so they will be held at +ve volts.
>
> Nick.
>
> W4ATK wrote:
>> When I use the CTRL key or ALT-K to toggle into keyboard mode, I get a
>> locked key, the DTR line goes high and stays there. In log mode the keyer
>> works as expected. Any suggestions as to what I might have wrong in the
>> setup or what the problem might be? The OS is WinXP SP2.
>
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 269.23.14/1425 - Release Date: 5/9/2008
> 12:38 PM
>
> No virus found in this outgoing message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 269.23.14/1425 - Release Date: 5/9/2008
> 12:38 PM
>
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|