Del & Jan Seay wrote:
> Locate the PBF/Front End Board, and remove. (Bottom under the
> shield.) Identify R-14, a 470 ohm resistor immediately adjacent to
> connector 24. Remove and replace with a 220 ohm resistor.
> Now - with the board positioned to where the resistor you just
> changed is next to you, and with the connectors 18 and 17 to you
> left, look for another 470 ohm resistor directly to the left of
> connector 24. There will be three others between it and connector 24.
> Remove that resistor and replace with a jumper.
In the 9/95 edition of the Omni 6 manual R-14 is identified as 220 ohms.
Obviously the rest of the mode would not show in the schematic. I haven't
pulled the board to check this out. Next time I delve in, I will. In the
mean time has anyone else with a new radio checked?
73, de Art
Art Searle, WU2K, NY, ARRL Life Member, QRP-L #524, QRP ARCI #9123
NorCal pending, DXCC MX & CW HR , NRA Benefactor Life Member,
NRA Certified Firearms Instructor, Dale Earnhardt Fan Club
Yosemite Sam "I'm a rootin' tootin' shootin' son of a gun"