The other night I switched my Titan PS from low voltage to high voltage while
the Titan was on and warmed up (but not transmitting). I don't see in the
manual that you're not supposed to do this. Anyway, the 20 amp fuses blew.
So before replacing the 20 amp fuses I make sure the power supply is in the
High voltage position, I replace the fuses and, the fuses blow again olus
there's this burning smell.
I open up the PS and see that the large 25 watt, 10 ohm wirewound resistor R1
is burned up.
I call up Ten Tec the next day and they want the power supply (with the
transformer taken out and sent separately) and the RF deck. That's a lot of
shipping. Before I package it all up and send it to TN, any ideas???????????
Anyone else had this problem?????
Thanks and 73, Doug W2CRS
FAQ on WWW: http://www.contesting.com/tentecfaq.html
Administrative requests: tentec-REQUEST@contesting.com
Sponsored by: Akorn Access, Inc & KM9P