TenTec
[Top] [All Lists]

[TenTec] Scout: QRP/QRO mod

To: <tentec@contesting.com>
Subject: [TenTec] Scout: QRP/QRO mod
From: d_perrin@conknet.com (David Perrin)
Date: Thu, 06 Mar 1997 17:00:05 -0800
Hi- 
        I have been reading many messages in the last few
months about finding a method of switching between QRO and 
QRP on the Scout.
        It is a pretty easy modification to do this, just
a little "will power".
        You'll first need to drill a small hole for a 
minature spst switch on the rear panel. I drilled mine close 
to the right hand edge of the cabinet as you face the radio 
rear; half way in height between the "key paddles" and 
"key" jacks. Find a place to run a wire from either switch 
terminal to ground. Connect another wire to the other terminal, maybe
8 inches long.
        Next is a little more complicated and time consuming.
 Locate the POT. on the underside of the cabinet where you can 
adjust the power level. That's where your going. It is R14 on 
the LLD/ALC board. You need to solder the end of the wire to 
the lead of R14 which goes to transistor Q3. I removed the board 
enough so I could solder the wire onto the trace of the pc board.
(That is the tricky part). 
        Last I set my maximum power using the POT. for 40 Watts.
When I turn the toggle switch, it grounds the emitter of Q3 and
my power drops to 4 Watts. I then orientated the switch so that 
"up" is QRO, and "down" is QRP.
        Simple. I did that two years ago, it works fine for me.
        Let me know if I can help.
  
  73 de Dave, K1OPQ

--
FAQ on WWW:               http://www.contesting.com/TenTecFAQ.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Sponsored by:             Akorn Access, Inc. & N4VJ / K4AAA

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Scout: QRP/QRO mod, David Perrin <=