Ten Tec Gang,
I am getting ready to install a Model Voice Readout Board into a Paragon
585. The board was previously in an Omni VI. The Instructions say that for
installation in a 585 you must install a diode, and give a location on the
board for the diode. The location of the diode on the board has no plated
through holes, so the location is not clear. Nearest I can figure the diode
goes between the 'not SPCH' pin on the edge connector and pins 12 and 13 of
U9 a 7400, with the cathode end towards the edge connector. This requires
cutting a trace on the board.
Can anyone confirm this or correct me if I am wrong?
Thanks in advance,
George Ar?hur Talbo? V73GT AH8H ex WB6VPS ZD8GT ZD7GT ZD9CR
Raytheon Range Systems Engineering Support
United States Army Kwajalein Atoll
Roi-Namur Island, Marshall Islands
9 Deg 23' 47" North 167 Deg 28' 31" East
Islands On The Air IOTA OC-28
Pacific Inter Island Net 0800 UTC 14.315 USB Nightly
Other Times available by Schedule
Bach, Beethoven, Mozart, Morse !
Paper Mailing address.
George Arthur Talbot ???
APO, AP 96557-8358
United States of America
Commercial voice 805-355-6473
Commercial FAX 805-355-6377
Pacific DSN 480-6473
CONUS DSN 254-6473
DSN FAX -6377
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com