Hi Jack. Did you by chance see my posting on the list earlier about
this? I'm wondering how old your kit is, since I built mine this summer.
I run 1200+ watts on HF here with none of the memory reset problems you
describe, and a similar antenna setup, although I have installed an
electrolytic in the optional spot (the one that's recommended for mobile
use) of 2200 uf. 4700 uf is the value Ten Tec recommends; I just had the
other handy. I've had none of the described problems with my 1220/1222
at either high or low power settings. I do run the transceiver from a
different power supply than my HF rigs, as well.
The troubleshooting guide in the manual also has some suggestions for
checks if the microprocessor isn't starting up properly.
3.2 watts sounds a bit low; I measure 4 watts on low power here, and 40
watts on high power. The manual does indicate that with amateur grade
power meters, 3-7 watts indicates that the transmitter is working
properly. If you have a Bird 43 with a 5 or 10 watt VHF slug, then I'd
I regularly use repeaters 40-50 miles from this location without
trouble, and I regularly hear repeaters in Baltimore, though I can't
The strongest RF fields my 1220 operates in are my own, so I have no
experience with susceptibility to strong AM broadcast fields.
Jack Kovar wrote:
> I have had similar problems with our 1220 5 watt kit.
> I would recomend no one buy this unit until the following problems are
> delt with.
> 1. All the memories are set back to 146.52 mhz often when car is
> 2. All memories are set back to 146.52 mhz when radio is turned on in
> high RF field. Example: 1000 watts at 3.9 mhz with dipole 40 feet from
> radio, SWR 1.5.
> 3. Maximum RF power out of my labeled 5 watt rig is 3.2 watts.
> I rewraped and nugged coils 3 times.
> 4. Squelch is too choppy in need of different histeresis setting.
> 5. Front end is possibly related to item 4 problem. Broadcast
> transmitters eat up my receiver.
> MY 1220 now collects dust as it lets me down when I need it most.
> I have used it as a single frequency packet station with good
> ANYBODY WANT TO BUY A PACKET RADIO ?
> I would very much like to fix most of the quirks.
> ANYBODY HAVE A HANDLE ON THIS RADIO YET ?
The Topsail Group, West Chester PA USA
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com