[Top] [All Lists]

[TenTec] Titan Plate Voltage ?

To: <tentec@contesting.com>
Subject: [TenTec] Titan Plate Voltage ?
From: kelsallp@postoffice.co.uk (Paul Kelsall)
Date: Fri, 7 Nov 1997 19:36:42 -0000

If your voltage is looking a little low, check the resistors on the metering
circuit-board. These seem to gain resistance as they age and therefore the
meter starts to show lower voltages. If you use a DVM and an High-Voltage
probe you will probably find that the HT is fine, change the resistors and
the meter reads like new.

73 de Paul G0CYB

-----Original Message-----
From: Setzler, James M <Setzler_James_M@code80.npt.nuwc.navy.mil>
To: 'tentec@contesting.com' <tentec@contesting.com>
To: <tentec@contesting.com>
Date: 07 November 1997 14:03
Subject: [TenTec] Titan Plate Voltage ?

>What plate voltage (load and no-load) would one expect to see on a
>properly operating relatively late model (5-6 years old) Titan?
>thanks & 73  James / k1sd
>FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
>Submissions:              tentec@contesting.com
>Administrative requests:  tentec-REQUEST@contesting.com
>Problems:                 owner-tentec@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm

FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>