I use the Heil Pro-set with the HC-5 element & it works fine with my
VI. My settings are:
Mic Gain at 9
Hope the resistor modification corrects your problem.
> From: L. L. Lamb <W4NL-KA4S@worldnet.att.net>
> To: firstname.lastname@example.org
> Subject: [TenTec] Omni VI+
> Date: Thursday, November 13, 1997 12:58 PM
> Good morning.....
> As said, I use the Heil Pro-set with the HC-4 and have tired the HC-5
> other rigs. The HC-4 seems better with my voice. The mike gain is good
> the 9 O'Clock position. The VOX gain is set at the "15" position and on
> the ragged edge of not being enough. I've played around with the avox
> delay levels, and while they have some effect, it's hardly where I wish
> to be.
> The question being, if I change the resistors would I not create more
> for my mike into the audio input of the tx and have to run the mike gain
> lower while not increasing the VOX gain? I say this since Ten Tec tells
> the VOX gain is picked up after and is part of this audio amp circuit.
> Heil is used by others with completely different results vis a vis have
> run the mike gain at much higher levels, etc. All I need is more VOX
> Any comments?
> 73, Lynn W4NL
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: email@example.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: firstname.lastname@example.org
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com