At 07:57 PM 1/16/98 EST, WO8L wrote:
>I'm not seeking help from Ten Tec's service department. Let me make that
>clear from the start.
>However, I have a problems which continues to occur on an Argosy SWR/S meter.
>It seems to warp when it gets hot and bend at one upper edge. This causes
>meter to stick when a signal hits S-9.
>I'd like to know how to get into the rig and bend the little devil back
>The rear of the meter seems sealed tightly and I hate to pry it off. Does
>front plastic pop off the meter section?
>I can't send it to Ten Tec every time it starts to stick. I'd be shipping
>dickens a lot to Sevierville.
>Just thought somebody would know.
Rick, once you do get that fixed, (I don't have the answere for that untill I
take my cover off to look at mine) but I would use a higher voltage backlit
bulb. Like say 15 or 18 volts. That will operate at less brightness and
less heat. You also can move the bulb away from the back of the meter as
If I remember right, the meters are 2 piece plastic and glued together.
(just going from memory) Here on mine, I use an 18 volt bulb and it
brightness and creates less heat in there. Hope that can help you some.
73 and keep ten tec'n.......Steve
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com