Scott, I just recently purchased a Paragon. I had called Scott at Ten
Tec before my purchase to inquire if it was possible to lower the output
on the Paragon. He rattled off the complete procedure, but I didn't
write it down since I didn't own one yet. So, if he can dictate it over
the phone, it must be factory authorized. I seem to remember him saying
the mod would take it down to 2 watts. BTW, mine goes down to about 23
watts right now, I'm planning on contacting Scott or the service dept.
soon to get the mod again.
Hope this helps.
Scott Rosenfeld [NF3I] wrote:
> Have a Paragon.
> Min power output is about 10 watts (factory spec says 25).
> I NEED to go lower. Anyone know of a factory-authorized modification?
> * Scott Rosenfeld NF3I Burtonsville, MD FM19mc QRV 80-10/6/2/440 *
> * 6m 82 grids on 8w * DXCC WAS WAC * QRP-L #147 * QRP ARCI #9054 *
> * http://w3eax.umd.edu/~ham * ARRL Life Member /Laurel ARC/UMARA *
> *** 301-549-1022 h 301-982-1015 w *** 35 wpm HF mobile CW Neon ***
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: firstname.lastname@example.org
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search.htm
R. Eric Sluder, KB9BGS
Carmel, IN USA
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com