I am assuming you have checked any and all coax jumpers in your shack from
antenna switches to tuners, etc. Then check antenna output connector on
Omni. Don't mean to treat you like a dunce, and am sure you did all this.
Let me tell you what I ran into. On my Omni-C, the diodes which generate
the ALC voltage (maybe they are on the SWR-TR board, but I am not sure) went
south. When my Omni-C did not have the ALC voltage, turning up the drive
control past a certain point would put the rig into a self-oscillation.
Replacing the diodes fixed the problem for me. That is an esoteric
possibility (my specialty) from my experience. That might well explain the
problem you are having. I sure hope it does. Please advise what you find
so that all of us can benefit from your findings. 73
401 E Holston Ave
Johnson City, TN 37601-4009
From: Loren Willis <firstname.lastname@example.org>
To: email@example.com <firstname.lastname@example.org>
Date: Monday, April 20, 1998 12:11 AM
Subject: [TenTec] Problems with OmniD (mod B)
>Suddenly noticed poor behavior on the part of my OmniD (546) model B.
>On at least half the transmissions, between 10 and 20 seconds into the
>transmission, the SWR meter jumps to show an ratio of 10-1(from under
>2-1), and a 60 cycle hum starts coming out of the power supply.
>Receiving stations report a terrible drop off in signal.
>The problem does not seem to be antenna related as it effects both my
>vertical and my dipole. The dipole is fed with ladder line, and the
>vertical has brand new coax, so feed line contamination seems doubtful.
>Any ideas of where I should start looking?
>73 de N0VYY
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Administrative requests: tentec-REQUEST@contesting.com
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com