The FL-7000 works fine with the TenTec QSK scheme. If you watch the
red lights on the front of the amp, it tells you that the transfer scheme
waiting for all to make the receive/transmit transition. I assume you are
the PTT input from the Paragon (TX OUT), and the TXINH for the TX Enable
back to the Paragon.
I f you are using the Paragon relay out to drive the FL-7000 PTT input, it
is still okay as the microprocessor in the 7000 will not allow drive to be
applied until the relays have all energized. In either case, you are
from "Hot Switching".
If you decide to replace the FL-7000, do it for a legitimate reason, not
that it doen't like the TenTec, because it does.
By a legitimate reason, I mean the fact that the FL-7000 is very fragile
a lot of maintenance, and is very expensive to repair. (I have one that I
have replaced the PA's at least a dozen times at over $100.00 per time.
It's been relagated to holding down the floor in my shop.)
> From: Robb Urie <firstname.lastname@example.org>
> To: email@example.com
> Subject: [TenTec] Paragon Mod??
> Date: Sunday, April 26, 1998 5:14 PM
> I just bought a mint Paragon, so far it plays well, minus an occasional
> drop in receive. My question is, can the Paragon be modified for MARS?
> I would like to use this rig on AF MARS. Any hints would be welcomed.
> Also, any ideas on the cw delay when using a non-TT amp. I have a Yaesu
> FL-7000 that I tried, but it does not like the delay. Should I sell it
> look for
> a centurian or titan? I do love the QSK system, should have gotten one of
> years ago.
> Robb...N0RU / AFA4DE
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: firstname.lastname@example.org
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com