The original message thread was entitled "[TenTec] modifying Omni V for QRP
?" How did it change to "Omni VI? Did you manually enter or change it?
Dan's question related to a modification on the Omni V, not Omni VI. The
stock Omni V is only capable of reducing its power to approximately 15
watts. Paul Clinton, Ten-Tec's Service Manager, advises to replace R46 on
the 9 MHz Filter Board from 100K-ohm to10K-ohm @ 1/4 watt. This brings the
Omni V's minimum output level to QRP.
From: Allan G. Taylor <email@example.com>
To: firstname.lastname@example.org <email@example.com>
Date: Friday, June 12, 1998 12:23 PM
Subject: [TenTec] Modifying OmniVI for QRP
>The OmniVI has an infinitely variable power level pot. Why on earth would
>want to chop up an OmniVI when one merely needs to crank down a pot level.
>on the front level to boot!!
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Administrative requests: tentec-REQUEST@contesting.com
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com