How about the old 2.5 mh choke to ground trick...............
> Since one satisfied user already posted that it works, here is the math to
> show how little power it costs.
> To: email@example.com
> From: rohre on Wed, Sep 16, 1998 3:45 PM
> Subject: RE: [TenTec] Aux Antenna
> Look at the difference in 50 ohm antenna vs. 100,000 ohms. You would have a
> current that was very small being drained from the transmitter power going to
> 50 ohms. The transmitter would primarily see the 50 ohm antenna, or whatever
> the antenna low impedance is, and hardly miss the minute drain to the 100000
> ohm ground. Consider that your insulators on the antenna when wet might be in
> the megohm range, where you would lose a microwatt of power.
> Lets say you have 50 watts from the TX. The ratio of the antenna impedance to
> the resistor is 1/2000. If it were 1/1000, it would lose 50 mw, but at
> 1/2000, it is only 25 mw. If you run QRP, just make the resistor something
> larger like a meg ohm. The idea is just to have some bleed off path for
> static voltage. In case of direct hit, it is toast anyway or for any size
> resistor, so it can be a low wattage carbon, but best sealed in epoxy so it
> won't get wet.
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: firstname.lastname@example.org
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com