[Top] [All Lists]

[TenTec] Ten Tec kits counting Toroid turn

To: <tentec@contesting.com>
Subject: [TenTec] Ten Tec kits counting Toroid turn
From: rohre@arlut.utexas.edu (rohre)
Date: 13 Nov 1998 16:54:04 -0600
All toroid winding is done by counting as a turn the wires passing the inner
diameter of the core.  IE, count the wire as one turn as it goes into the hole
in middle.  That way, you will not get confused with the ends.

Good Luck!
Stuart K5KVH

FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Ten Tec kits counting Toroid turn, rohre <=