[Top] [All Lists]

[TenTec] Delta II computer control. model 305 converter?

To: <tentec@contesting.com>
Subject: [TenTec] Delta II computer control. model 305 converter?
From: kg5u@hal-pc.org (Dale L. Martin)
Date: Fri, 13 Nov 1998 22:46:29 -0600
Hi, Tim.

I have a Delta II which I purchased to use as radio2 for

I purchased the Model 305 for the RS232 level conversion that is
necessary for computer control of the Delta II.  You could just
as well build your own.  My 1995 ARRL Handbook for Radio Amateurs
has the schematic and writeup on an RS232 level converter using
the same chip as the 305.

The baud rate is fixed at 1200 baud.

You may very likely need to know the 'receiver address'.  Mine is
64.  You can find and set your's by pressing the "F" button, the
<MODE button (That's the LEFT ARROW-MODE button).  On the LCD
display you will see HEX numbers (mine says EC.006.4) in place of
the frequency.  The 6.4 is the 64 receiver address for my radio.
You can change the number by pressing the Up or Down arrow
buttons.  (I'm telling you this in detail because I had to call
Ten-Tec service department to find out how to do this; it wasn't
in the manual.).

I found a problem with the computer/radio system that I am trying
to work through.  The computer software polls the radio for the
frequency once a second.  I have had to turn off the polling
while the radio is transmitting, otherwise the CW characters get
all chopped up and are unreadable.  With the polling off while
transmitting, only the first character is chopped (truncated?),
the rest of the CW is normal CW.  There are a couple of other
software commands I found in the logging program command list
that I am going to try this weekend and see if that will resolve
the first character chopping problem.

My radio1 is an Omni VI+ and I've had no similar problems with
it's computer control (same computer and same software).  So, I
don't know if the problems I am having with the Delta II are
endemic to the radio or if it's just a problem with my radio.

What is it again you want to do with the computer control of the
radio?  I'm not quite sure what you are saying.

73 and good luck,
Dale Martin, KG5U

-----Original Message-----
From: Tim Cook <timcook@erinet.com>
To: [Ten Tec] - Reflector <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Friday, November 13, 1998 19:13 PM
Subject: [TenTec] Delta II computer control. model 305 converter?

>I looked back through the archives of this reflector, but could
find very
>little on using a computer to control the Delta II. I surmise
the IC-735 is
>the same control set.  Are there any preferred rs-232
converters?? Is the
>model 305 Ten Tec a good one? (if it can be found)..
>I am not really looking for something to control the memories
from the
>computer, so I can put in Utility frequencies, etc....
>Thanks for any info and/or experiences
>FAQ on WWW:
>Submissions:              tentec@contesting.com
>Administrative requests:  tentec-REQUEST@contesting.com
>Problems:                 owner-tentec@contesting.com

FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>