I have a Ten Tec Model 405 solid state amplifier with manual for sale.
This was built to take a QRP signal of 1 to 5 watts and amplify it to
about 50 watts. It is a no tune amp that will operate on all HF bands
from 80 to 10 meters. It is in perfect working condition and I have used
it to amplify the output of my QRP Plus rig with good results. Price is
$150 plus shipping.
Cosmetically, it has a few minor scratches, mostly on one side.
Someone's SS number is etched into the bottom. It has had mods as
follows: Power switch is different from original which failed; a
resistive attenuator is installed to reduce an input of about 8 watts to
5 watts or below; there has been a front panel switch added to switch the
attenuator in and out; the resistor in series with the meter lights has
been increased to dim them a bit and avoid burnouts.
The only reason for selling is that QRP is not my interest right now and
I am getting rid of my QRP gear.
When the wires go down and the lights are out, when the phones
are dead and the internet with them, your message can still get
through by amateur radio! Robert J. Lees, P.E.(Bob),
King of Prussia, PA USA Amateur radio call W3ZQN
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com