The symptoms you describe happened to my Omni when I was attempting to
build up a supply for it. When the supply voltage dipped the rig
would do similar strange things.
When I put it back on a known and adequate supply the problem
The solution was two fold:
1) make sure the power supply can deliver the needed current!
2) push the reset button on the right hand side of the Omni V
TenTec also suggested I try the following reset procedures:
1) Power down -- push and hold the reset button when you power up
and then after a about 5 seconds release the reset button.
2) Power down - Hold the CLR/CLK key and power up - release the
CLR/CLK key after you hear the beep!
Does the problem persist when in receive only? Does it suddenly occur
after the first transmit? Does it occur at low power?
I hope the problem can be resolved without the need to re-align. Good
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com