Got it! I'm listening to the 14.1 beacons (and a bit of packet) as I type.
Clark, as your mail was being downloaded I was struggling with the screws on
the bottom plate (now, they were REALLY tight). With receive and xmit both
affected I expected a bad connection on the 9MHz board . Much to my
surprise, the default 9MHz filter was completely loose! I didn't even know
it was replaceable. So now I'm happy again.
Thanks all for the suggestions.
73, Bruce, W3GDZ
----- Original Message -----
From: Clark Savage Turner <firstname.lastname@example.org>
To: Bruce L. Bevelheimer <email@example.com>
Sent: Sunday, August 01, 1999 8:50 PM
Subject: Re: [TenTec] OPTION 3 upgrade
> Hi Bruce -
> A common problem is the filters break loose because the UPS
> gorillas have a party. Open the rig and pull the main filters
> out and carefully push the pins back in to make sure they are
> Secondly, check ALL board connectors to see that they are seated,
> it is really not that hard for them to come loose in shipping,
> Ten Tec can't really prevent all of that from happening.
> Just be patient and look it over, it will turn out allright
> in the end!
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: firstname.lastname@example.org
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com