yes, there is. Check the schematic and jumper the Molex connector before
arriving at any further conclusions.
Vy 73, AI2Q, Alex in Kennebunk, Maine .-.-.
> -----Original Message-----
> From: firstname.lastname@example.org [mailto:email@example.com]On
> Behalf Of James D. Duffer
> Sent: Friday, August 06, 1999 7:25 AM
> To: Jim Reid
> Cc: firstname.lastname@example.org
> Subject: Re: [TenTec] Blown PS 962
> > This time, had presence of mind to disconnect the PS from
> > the Omni. Put in another fuse, turned on the power -- nothing,
> > no pilot light. Checked the fuse, was not blown.
> > So, obviously I made an error putting in the 10 amp fast blow
> Maybe, maybe not......with the power supply disconnected from the Omni
> VI, how did you turn the power supply on? Isn't there a a pair of
> wires that must be connected together via the power on/off switch
> located on the Omni? Just wondering, and I haven't taken time to look
> at my set up this morning.
> Wish you luck with it.
> Jim, WD4AIR
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: email@example.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: firstname.lastname@example.org
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com