[Top] [All Lists]

[TenTec] High Z vs. Low Z mics (Omni C).

To: <tentec@contesting.com>
Subject: [TenTec] High Z vs. Low Z mics (Omni C).
From: geraldj@ames.net (Dr. Gerald N. Johnson, P.E.)
Date: Sun, 03 Oct 1999 20:54:03 -0500
PTO takes about three hours the first one. The kit is needed. Parts are
worn. Grease is hard.

A 200 ohm mike won't likely put out any where near enough voltage to be
useful, unless you go find a RS low Z to hi Z transformer adapter and
wire it between your low Z mike and the Omni C. Impedance mismatch won't
hurt frequency response or anything, just there won't be enough voltage
without a transformer.

73, Jerry, K0CQ

FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>