It works just fine without any reconfiguration of the port.
Those port parameters are only defaults.
From: Jay Townsend <email@example.com>
To: Carl Hyde <firstname.lastname@example.org>
Cc: Ten Tec <email@example.com>; writelog <firstname.lastname@example.org>
Date: October 08, 1999 3:10 PM
Subject: Re: [WriteLog] Omni V and Writelog
>At 08:56 PM 10/7/99 -0700, Carl Hyde wrote:
>>Ive had WriteLog Version 10 for a few days and have
>>gotten the hang of the software to the point where I
>>wanted to use it to control my Omni V. I made up a
>>serial cable using pins 2, 3, and 7 from the radio to
>>my computer. WriteLog says it will work with just TXD,
>>RXD and signal ground. I know the serial port works
>>because I use the same port for my TNC. I have gone
>>through the settings numerous times and the program
>>still will not interact with the Omni V.
>I have no express knowledge of the Omni V but if you are using only a 3
>wire cable then you PROBABLY need to change
>your Win95/98/NT settings on the Serial Port.
>Click Start--Settings--Control Panel--System >> Device
>Manager--Ports--ComX--Port Settings...can't use Hardware Flow control with
>no hardware wires.
>Jay Townsend, WS7I < email@example.com >
>Administrative requests: writelog-REQUEST@contesting.com
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com