[Top] [All Lists]

[TenTec] Re: [WriteLog] Omni V and Writelog

To: <tentec@contesting.com>
Subject: [TenTec] Re: [WriteLog] Omni V and Writelog
From: SteveBaron@starlinx.com (Steve Baron - KB3MM)
Date: Fri, 8 Oct 1999 14:20:27 +0100
It works just fine without any reconfiguration of the port.

Those port parameters are only defaults.

-----Original Message-----
From: Jay Townsend <ws7i@ewarg.org>
To: Carl Hyde <cshyde@yahoo.com>
Cc: Ten Tec <tentec@contesting.com>; writelog <writelog@contesting.com>
To: <tentec@contesting.com>
Date: October 08, 1999 3:10 PM
Subject: Re: [WriteLog] Omni V and Writelog

>At 08:56 PM 10/7/99 -0700, Carl Hyde wrote:
>>Ive had WriteLog Version 10 for a few days and have
>>gotten the hang of the software to the point where I
>>wanted to use it to control my Omni V. I made up a
>>serial cable using pins 2, 3, and 7 from the radio to
>>my computer. WriteLog says it will work with just TXD,
>>RXD and signal ground.  I know the serial port works
>>because I use the same port for my TNC. I have gone
>>through the settings numerous times and the program
>>still will not interact with the Omni V. 
>I have no express knowledge of the Omni V but if you are using only a 3
>wire cable then you PROBABLY need to change
>your Win95/98/NT settings on the Serial Port.
>Click Start--Settings--Control Panel--System >> Device
>Manager--Ports--ComX--Port Settings...can't use Hardware Flow control with
>no hardware wires.
>Jay Townsend, WS7I  < ws7i@ewarg.org >
>Submissions:              writelog@contesting.com
>Administrative requests:  writelog-REQUEST@contesting.com
>Problems:                 owner-writelog@contesting.com

FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Re: [WriteLog] Omni V and Writelog, Steve Baron - KB3MM <=