The dial accuracy on the Delta 580 is somewhat lacking because of the way
the frequency is counted. If memory serves, the counter does NOT count the
band crystal. That means the display can be off by different amounts on
different bands. The only way to fix that is to put padders on the crystals
to bring them to the precise frequency they should be on. I do not believe
that those padders (trimmers or whatever) are in the rig as it was
About the dial, there is supposed to be a pair of felt washers behind the
tuning knob - between it and the dial skirt. If they are worn, you can take
them off and turn them back to back to put fresh sides on the outside
(touching the skirt and the knob). The procedure is to loosen the setscrew
on the knob and while pushing it toward the rig, tighten the setscrew. This
will give you the friction you want. I would assume the tuning gets a bit
tighter in cold weather because the grease in the mechanism gets more
viscous - normal.
The fact that the audio goes away when you select the narrow filter could be
several things. I don't recall if the audio filters switch with the crystal
filters or not. Perhaps your filter has come loose from its socket -
perhaps it is bad. Perhaps the IF frequency crystals are not set properly.
You are on your own with that one.
Luck to you -- Regards, Mike N4NT@wireco.net
----- Original Message -----
From: John Scott <firstname.lastname@example.org>
To: TenTec <TenTec@contesting.com>
Sent: Friday, October 08, 1999 10:23 AM
Subject: [TenTec] Delta 580
> I have a nice Delta that I am using for mobile operation. It needs a tune
> I have the manual and am about to dive in to it. Does anybody have any
> Tips that can help with the tuneup?
> Some of the problems that I have already identified:
> 1. The display accuracy is about 2Kc low from where the actual frequency
> 2. The tuning knob is too easy to turn and I end up changing frequency
> each bump.
> 3. On cold AMs the tuning is much firmer.
> 4. Almost zero audio when I select the sharpest filter.
> The box has all the crystals etc, to cover all the bands.
> Many thanks
> John KK5VH
> Round Rock, TX.
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Administrative requests: tentec-REQUEST@contesting.com