Hi Ken,
Thanks for the waking me up. I was interpreting the darned SWR scale !!
My Titan supply is at the High psn, 2400v, needle right at the hash mark
where the red zone begins. Low psn gets 1800 volts at power-on, then
drifts to settle at about 1700.
73, de Joe - AA4NN
"ken k7zum" <k7zum@teleport.com> writes:
>
> ----
> you must be running on the low voltage side, as the high side is
> about 2400 volts
>
> Ken...k7zum
>
>
> >
> >Idle plate voltage is 1800v.
> >
> > Freq Drive Pma Gma Ant
> >
> > 1.820 35w 800 20 3/8 wave Inv L
> > 3.520 30w 750 25 Dipole 90'
> > 7.020 50w 900 25 40-2CD 100'
> >14.020 50w 900 25 PRO57-B 92'
> >21.020 40w 850 20 "
> >28.020 40w 900 15 "
> >
> >These are my readings, others may vary. Hope this helps.
> >73, de Joe - AA4NN
> >
> > "Lane Zeitler" <Ku7i@worldnet.att.net> writes:
> >>
> >> Gents,
> >> For those of you running the Ten Tec Titan I:
> >>
> >> 1. What is the idling plate voltage?
> >> 2. Plate I at 1500watts out?
> >> 3. Grid I at same power level?
> >> 4. Drive level needed for same?
> >>
> >> Any info greatly appreciated.
> >>
> >> Lane
> >> Ku7i
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|