TenTec
[Top] [All Lists]

[TenTec] Pegasus beta software

To: <tentec@contesting.com>
Subject: [TenTec] Pegasus beta software
From: at060@chebucto.ns.ca (David McClafferty)
Date: Sun, 19 Dec 1999 20:45:55 -0400 (AST)


On Sun, 19 Dec 1999, Steve Ellington N4LQ wrote:

> 
> I can't see the Pegasus controlling the Hercules unless an interface
> is installed. The Herc requires a gounded lead to activate each band
> relay. It was easy rigging it up with the old Omni C but the Pegasus
> has no external connector. After looking over the schematic of the
> Pegasus, it wouldn't be difficult at all to tap into the coil of each
> band relay and use those voltages to activate small relays external to
> the rig and key the Herc. All it would take is some multiconductor
> wire and no software changes are needed.
> Steve N4LQ

Do you have schematics for the Pegasus? Someone mentioned they were
available for the asking but when I called the Tentec repair number they
said they didn't think they were available yet. They are still using their
original shop copies. Maybe I should call the sales number. I was thinking
about using relays connected as you mentioned to switch antennas but now
that I have the version 1.63 software I can use the antenna switch
provided by Log-EQF via the printer port. That should work for a linear as
well and is easier to get at than tearing into the Pegasus.

                                        73, Dave, VE1ADH



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>