TenTec
[Top] [All Lists]

[TenTec] Argosy II bandswitch problem

To: <tentec@contesting.com>
Subject: [TenTec] Argosy II bandswitch problem
From: K2ZF@aol.com (K2ZF@aol.com)
Date: Fri, 2 Feb 2001 19:59:14 EST
In a message dated 2/2/01 12:15:28 PM !!!First Boot!!!, va3pkh@rac.ca writes:

<< 
 I have borrowed an Argosy II from a friend who has not used it for
 years.
 The 29.0 position in the band switch results in all zero's on the
 readout and
 very little audio. The tuning knob makes no changes in frequency.
 All other positions work fine. I was wondering if there was a simple
 answer to this problem or does this need extensive repairs ?
 
 Thanks in advance for any advice,
 
  >>

Peter, maybe that band was an option and the crystal was not installed. If 
that is the case, then there is the reason that bandswitch position is not 
working.
73 de Jim  K2ZF

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Argosy II bandswitch problem, K2ZF@aol.com <=