TenTec
[Top] [All Lists]

[TenTec] Jupiter Computer Control in non-Pegasus Mode

To: <tentec@contesting.com>
Subject: [TenTec] Jupiter Computer Control in non-Pegasus Mode
From: ka8jxg@callsign.net (Carl J. Denbow)
Date: Fri, 11 May 2001 17:16:03 -0400
So far I've received two "off-list" responses to this query.  One 
said it was possible but gave no details.  The other said that in 
non-Pegasus mode the serial port could only be used for firmware 
updates.  Would anyone like to go "on-the-record" with a response and 

enough details to know what codes are used, if this is possible?  
I've heard that the OMNI rigs use ICOM-compatible codes?  Is this 
what the Jupiter would use in non-Pegasus mode?   Thanks for any 
further clarification anyone can give.
 
73  
 
Carl
 
On Thu, 10 May 2001 23:34:26 -0400,  wrote:
>Does anyone know if the Jupiter can be computer controlled when it
>in non-Pegasus mode? That is, will it recognize any commands coming
>through the serial port. This would certainly be a nice feature. 
I've
>found that I often like to use the rig with the knobs rather than 
the
>software. At the same time I'd like to have my logging program be
>able to "speak" to the Jupiter and also "hear" its frequency
>information. Anyone know about this? Thanks.
>
>Carl
>

================================
Carl J. Denbow
KA8JXG
17 Coventry Lane
Athens, Ohio USA
 
EM89
Working on WAS and DXCC
================================
Message sent from ka8jxg@callsign.net on 05/11/2001


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>