TenTec
[Top] [All Lists]

[TenTec] Scout problems

To: <tentec@contesting.com>
Subject: [TenTec] Scout problems
From: wb2vuf@qsl.net ( Bob, WB2VUF)
Date: Sat, 27 Oct 2001 19:48:12 -0400
Here is the procedure that I use to assure an optimum fit for the band
modules:

Remove the knobs. Remove the top and bottom covers. Remove the 4 screws
that hold the sides of the front panel to the chassis. Loosen the two
nuts on the control shafts.

Now plug in a band module. Install and tighten the 4 side screws on the
front panel. Tighten the control nuts. Reinstall the covers and knobs.

                        73,

                        Bob WB2VUF

Stuart Rohre wrote:
> 
> I believe the original Bob who posted on Scout display jumping around later
> posted he found bad plug in connection of the band modules, he could not
> plug them in all the way.
> 
> This could be a mechanical problem of the guide and slot used on the
> modules, and I sent him some things to check and fixes for tight modules,
> mainly you put a Little grease on the track to ease them in!
> 73,
> Stuart K5KVH

<Prev in Thread] Current Thread [Next in Thread>