| To: | "Corey Chaney" <jcoreyc@yahoo.com>, tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Too wide a signal.... |
| From: | W2AGN <w2agn@pobox.com> |
| Date: | Sat, 10 Nov 2001 17:36:16 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
On Saturday 10 November 2001 17:06, you wrote:
> Just got an OO Advisory Notice that my Omni C was apparently too wide on
> 40M (CW). I can't figure out what could be wrong, but obviously something
> is.
>
> Any suggestions?
>
> Corey (KF0UN)
--
Check it out independently. OO's are NOT "Official." There have been some
unable to tell the difference between a wide signal and overloaded receiver.
Or, you might have QRmed him, and he is "getting even." Check it out.
--------------------------
John L Sielke W2AGN
w2agn@pobox.com
http://www.qsl.net/w2agn
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Too wide a signal...., Corey Chaney |
|---|---|
| Next by Date: | Re: [TenTec] Too wide a signal...., George, W5YR |
| Previous by Thread: | [TenTec] Too wide a signal...., Corey Chaney |
| Next by Thread: | Re: [TenTec] Too wide a signal...., George, W5YR |
| Indexes: | [Date] [Thread] [Top] [All Lists] |