I'm not sure that the RX-350 .ruf would contain all that is needed for the
Jupiter. I think that I will wait for Ten Tec to correct their problem or
the next version. Version 1.12 seems to operate fine, except for AM with
N4PY SW and the Noise Blanker, which could be a contained within N4PY SW..
Thanks and 73's,
----- Original Message -----
From: "J. Duffy Beischel" <firstname.lastname@example.org>
To: <email@example.com>; "Dudley Hurry" <firstname.lastname@example.org>
Sent: Friday, February 08, 2002 6:23 AM
Subject: Re: [TenTec] Jupiter 1.14 Update??
> They did leave it out of the Jupiter update. Dowload the update for the
> 1.14 firmware update for the Jupiter can be found in that download. That
is what I did to
> load 1.14 to my Jupiter. It will read 1.14 on the start up screen after
> Duffy - WB8NUT
> 2/8/02 2:36:41 AM, "Dudley Hurry" <email@example.com> wrote:
> >If you notice after "updating" your Jupiter, it may still say the
> >version that was there before at power up.... I noticed that the
> >"538V1140.ruf" file is missing.. I had flashed eariler to version 1.12,
> >and the radio still says 1.12.. I think Ten-Tec left the file out..
> >Thanks and 73's,
> >TenTec mailing list
> J. Duffy Beischel - Amateur Radio WB8NUT
> Member of: ARRL, NRA, Kiwanis, Republican Party, Masons, and Shriners
> and the vast Right Wing conspiracy to get the Clintons
> "If the government owned all the guns, would we still be a free people?"