[Top] [All Lists]

[TenTec] Omni C - No TX

To: <tentec@contesting.com>
Subject: [TenTec] Omni C - No TX
From: ke8npjmj@ameritech.net (JERRY JUDY)
Date: Mon Apr 21 07:47:21 2003
Inside the ps is a 20 amp fuse on the ps circuit board. I would bet that
fuse is blown.  This condition lets the recieve work but high current of
xmit is gone. Let me know if I am right?   KE8NP

----- Original Message -----
From: "Jeff Stewart" <stewgoat@indy.net>
To: <tentec@contesting.com>
Sent: Sunday, April 20, 2003 10:36 PM
Subject: [TenTec] Omni C - No TX

    While adjusting my MFJ antenna tuner, my Omni C kicked out of transmit
(too high an SWR I assume).  In the past, just shutting the rig down then
powering up would reset it.  Now every time I key the mic or use the lock
position, it shuts down but will return to receive when unkeyed.  The Omni
and the 280 power supply both turn off on transmit but works fine in
receive.  Both the fuse on the power supply and the radio check fine with an
ohm meter.  What have I blown? ( I do have the owner's manual but I there's
no troubleshooting section.

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>