I just tried and oddly enough, Ten-Tec has gone to some sort of
Allen-head looking screws but none of my metric or American Allen
wrenches fit it. If I can find a tool I will open it and have a look.
----- Original Message -----
From: "Carl Moreschi" <email@example.com>
Sent: Tuesday, April 22, 2003 7:13 AM
Subject: Re: [TenTec] Pegasus: No Output
It really sounds like the 12 volt connection to the final board in the
pegasus is not connected. Inside the pegasus, this is a heavy red
runs from the low pass filter board to the final board. I would at
open up the pegasus and take a look at this wire to make sure it is
connected at the low pass filter board end.
Carl Moreschi N4PY