[Top] [All Lists]

[TenTec] Pegasus: No Output

To: <tentec@contesting.com>
Subject: [TenTec] Pegasus: No Output
From: jeff@ke9v.com (jeff@ke9v.com)
Date: Tue Apr 22 10:21:20 2003
I just tried and oddly enough, Ten-Tec has gone to some sort of
Allen-head looking screws but none of my metric or American Allen
wrenches fit it. If I can find a tool I will open it and have a look.

Thanks Carl!


----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Tuesday, April 22, 2003 7:13 AM
Subject: Re: [TenTec] Pegasus: No Output


It really sounds like the 12 volt connection to the final board in the
pegasus is not connected.  Inside the pegasus, this is a heavy red
wire that
runs from the low pass filter board to the final board.  I would at
open up the pegasus and take a look at this wire to make sure it is
connected at the low pass filter board end.

Carl Moreschi N4PY
Franklinton, NC

<Prev in Thread] Current Thread [Next in Thread>