TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Spurs

To: "Ten-Tec" <tentec@contesting.com>,"Bill Tippett" <btippett@alum.mit.edu>
Subject: Re: [TenTec] Paragon Spurs
From: "Michael Tope" <W4EF@dellroy.com>
Reply-to: tentec@contesting.com
Date: Tue, 16 Dec 2003 01:50:22 -0800
List-post: <mailto:tentec@contesting.com>
Hi Bill,

I checked my Paragon tonight with the VFO set to 1813.00 KHz.
The high-level close-in spurs that I saw on the 7MHz spectrum
are gone with this setting, but I am still seeing low-level discrete
spurs which in this case are at approximately +/-12.4 KHz offset
from the carrier. These spurs are about 25dB above the thermal
noise floor of my FT-847 and R4C which is similar to the levels
that I saw for the low level spurs on the Paragon's 7 MHz spectrum
(e.g. about 80dB below the carrier). There were some other spurs
that showed up on the FT-847, but I couldn't find them on the R4C,
so I'll have to assume that they were generated inside the FT-847.
As before, the input signal level to both of the receivers was set to
~-30dBm (S9+40dB).

It's interesting that the spurs you are seeing from your neighbors
Paragon repeat every 10KHz. I wonder, do they fall off in level
as you move away from the carrier (e.g. are the +/-20 KHz, +/-30
KHz, ...... spurs the same strength or do they get weaker as "N"
goes up)? If these are synthesizer reference spurs, its quite
possible that there is a fix for this. It might be worth a call to TT
service.

73 de Mike, W4EF......................................

P.S. You need to invite your neighbor over to play with the Orion.
Who knows maybe you'll get him hooked :):)

----- Original Message -----
From: "Bill Tippett" <btippett@alum.mit.edu>
To: <W4EF@dellroy.com>; <tentec@contesting.com>
Sent: Monday, December 15, 2003 3:25 AM
Subject: [TenTec] Paragon Spurs


> Hi Mike,
>
> Thanks for the checks.  If it is easy to do, check
> again with a fundamental of 1813 and see if the spurs
> are 10 kHz at that frequency setting.  If they change as
>   a function of the synthesizer PLL setting, it could be
> that is why I hear them every 10.000 kHz on 160.
>
> 73,  Bill  W4ZV
>
>





_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>