TenTec
[Top] [All Lists]

Re: [TenTec] Re: [Orion] Updating the Orion-set the baud rate

To: <tentec@contesting.com>
Subject: Re: [TenTec] Re: [Orion] Updating the Orion-set the baud rate
From: "Carl Moreschi" <n4py@earthlink.net>
Reply-to: tentec@contesting.com
Date: Tue, 23 Dec 2003 00:58:49 -0000
List-post: <mailto:tentec@contesting.com>
The baud rate you set your comport at is overridden by the Orion update
software.  The Orion only works at 57600 baud.  The speed you configure the
comport to in your windows settings is meaningless.

Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "john rader" <kd5yty@yahoo.com>
To: <tentec@contesting.com>
Sent: Tuesday, December 23, 2003 12:44 AM
Subject: [TenTec] Re: [Orion] Updating the Orion-set the baud rate


> My Windows 98 machine was set to 9600, no prob with 3 updates.
>
> I ran across this in the RF2 site,
> The  Orion Programmer's Reference Guide says: "Although the ORION
interface operates at 57,600 baud short commands are used to keep the
processing overhead to a minimum..."
>
> John KD5YTY
>
>
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Photos - Get your photo on the big screen in Times Square
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>