TenTec
[Top] [All Lists]

Re: [TenTec] Titan 425E caps

To: <tentec@contesting.com>
Subject: Re: [TenTec] Titan 425E caps
From: "GARY HUBER" <glhuber@msn.com>
Reply-to: tentec@contesting.com
Date: Sun, 18 Jul 2004 16:49:30 -0500
List-post: <mailto:tentec@contesting.com>
I am also an original owner of a TT 425 export model. Same type of meter 
readings since day one. Power supply is fed from a 240 VAC 40 Amp circuit with 
number 10 conductors. I always considered the lower plate voltage readings 
consistent with early Russian methods for calculating 200 W limit on their 
amplifiers. Lower plate voltage reading would make for more conservative power 
output.... HI HI !

Best regards,
Gary - AB9M
CSM(r)G.L.Huber
glhuber@msn.com<mailto:glhuber@msn.com>
www.csm-gh.com<http://www.csm-gh.com/>
9679 Heron Bay Road
Bloomington,IL 61704
(309-662-0604)
National Webmaster for:
The Society of the Fifth Division
www.societyofthefifthdivision.com<http://www.societyofthefifthdivision.com/>
  ----- Original Message ----- 
  From: Marcel Jorba<mailto:ea3in@yahoo.com> 
  To: tentec@contesting.com<mailto:tentec@contesting.com> 
  Sent: Sunday, July 18, 2004 12:30 PM
  Subject: Re: [TenTec] Titan 425E caps


  Thanks for all answers.

  If this is all the problem, I will live it.

  73, Marcel

  --- Joe Giacobello <k2xx@swva.net<mailto:k2xx@swva.net>> wrote:
  > I have precisely the same problem with one of my
  > 425's and had also 
  > concluded that a meter resistor is the problem.  I
  > am also living with it.
  > 
  > 73, Joe
  > 
  > ac5e@comcast.net<mailto:ac5e@comcast.net> wrote:
  > 
  > >Hi Marcel:  My 425 also indicates 1.8 "Plate
  > Kilovolts" on the front panel meter. I was
  > suspicious when that started, about five years ago,
  > since the drive wattage and Tune/Load settings
  > remained the same for the same power output so I
  > checked the actual HV out of the power supply. 
  > >CAREFULLY!!! 
  > >My power supply itself puts out 2,320 Volts when
  > the plate meter sits on the dot between the numbers
  > 1 and 8 in the 1.8 red scale. Running CW with 1500 W
  > measured output the actual voltage drops to 2,230 V
  > - while the meter on the Titan drops to just a bit
  > to the left of the 1 in 1.8. I suspect a dropping
  > resistor in the metering circuit, but I haven't been
  > curious enough to tear my setup down to get to the
  > circuitry. Too much work for too small a concern. 
  > >Now, I was suspicious for three reasons. Besides
  > the fact that my logged settings for max output had
  > not changed,  local hams who can hear me very well
  > and know my voice report NO AC HUM on my signal with
  > or without the amplifier in line. And the final
  > reason is that when the filter caps go bad there's
  > usually  a very substantial drop in voltage between
  > no load and full load. 
  > >If you don't show a big drop in HV between idling
  > and operating I would not worry too much about it.
  > If it worries you find a calibrated high voltage
  > meter or a probe that will work with a meter you
  > have and measure the HV at the power cable at the
  > back of the RF deck. And have everything hooked up
  > and metering - AND YOUR HANDS WELL CLEAR - before
  > you turn the power on!  Failure to do this can
  > result in a well done ham!!!! 
  > >If the HV meter agrees with the built in meter, you
  > may have a power supply problem worth fixing. If it
  > reads much higher than the built in meter you
  > probably have a voltage divider problem in the
  > Titan's metering circuit. 
  > >73  Pete Allen  AC5E
  > >_______________________________________________
  > >TenTec mailing list
  > >TenTec@contesting.com
  > >http://lists.contesting.com/mailman/listinfo/tentec
  > >
  > >
  > >  
  > >
  > 
  > _______________________________________________
  > TenTec mailing list
  > TenTec@contesting.com<mailto:TenTec@contesting.com>
  > 
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
  > 




  __________________________________
  Do you Yahoo!?
  Vote for the stars of Yahoo!'s next ad campaign!
  
http://advision.webevents.yahoo.com/yahoo/votelifeengine/<http://advisionwebevents.yahoo.com/yahoo/votelifeengine/>

  _______________________________________________
  TenTec mailing list
  TenTec@contesting.com<mailto:TenTec@contesting.com>
  
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>