TenTec
[Top] [All Lists]

Re: [TenTec] Orion and RX-320 on DRM

To: <tentec@contesting.com>
Subject: Re: [TenTec] Orion and RX-320 on DRM
From: "W1GOR" <W1GOR@Maine.RR.Com>
Reply-to: tentec@contesting.com
Date: Fri, 1 Oct 2004 08:20:34 -0400
List-post: <mailto:tentec@contesting.com>
Mark,

What is the IF of the RX-320..?   0.1uF sounds like a low Xc across the IF
output...  What was your reason for bypassing the IF output..?

73, Larry - W1GOR


----- Original Message ----- 
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Thursday, September 30, 2004 11:53 PM
Subject: [TenTec] Orion and RX-320 on DRM


> I have modified my Orion and my RX-320 to make the IFs available to use
with
> the Dream DRM decoding software.
>
> Listening to the RCI (Canada) DRM broadcast directed to NE USA this
evening
> and using the same anteana. The Dream software reports a signal to noise
> ratio.  The best I could get with the RX-320 was about 16 dB S/N which
> resulted in marginal DRM reception.  The Orion was 24 dB which was almost
> perfect reception.
>
> I know the Orion is a better receiver, but is this difference to be
> expected?  I am taking the IF's directly from the receiver insidee the
> respective radios. The only difference is that I put a 0.1 uF cap across
the
> output of the RX-320, I didn't do that with the Orion.  Do you think
> removing the cap would help?
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>