>Date: Tue, 02 Nov 2004 14:27:03 -0800
>From: "Adam N." <email@example.com>
>Subject: [TenTec] 544 freq display jumping on TX
>I have a nice 544 that has a problem where the freq
>readout jumps around while transmitting on some bands
> (15m comes to mind). It does not seem to be
> changing my actual output freq.
>When I use the remote VFO (for TX and RX) the problem
>stops. I've read through the archives on this
>reflector at some possible causes
>(PTO rebuild, dirty band switch, unstable osc) but
>I'm not sure which to attach first.
>Thanks in advance.
The most likely cause is RF getting back into the rig.
I had a 544 and it did this on a reglular basis.
First try the rig into a dummy load on the bands in
If that proves the RF problem, check grounding.
Perhaps by getting a good earth ground directly to
both the rig and the power supply, you will reduce the
Do you Yahoo!?
Check out the new Yahoo! Front Page.
TenTec mailing list