Re: [TenTec] OMNI D series C help please

["Steve N4LQ" <n4lq@iglou.com>]

Sell it to a sidebander and buy another one in better shape but first remove 
the wood screw.
Steve N4LQ
----- Original Message ----- 
From: "Tony" <g3zrj@morsekey.fsnet.co.uk>
To: <tentec@contesting.com>
Sent: Monday, November 08, 2004 5:36 PM
Subject: [TenTec] OMNI D series C help please


Hi,
I've dredged through the archives but so far have had no success re the 
following:

PTO backlash/hand capacitance
(I have fitted a piece of wire from a straightened out spring between the 
two screws securing the PTO assembly to the front chassis to earth the shaft 
of the PTO and to increase tension to reduce the "creep" when tuning LF 
which causes the VFO to move about 300 to 500 Hz on a "semi random" basis on 
release of the tuning knob.    Is this an acceptable means of attacking the 
problem? - or am I likely to distort the PTO mechanism?

QSK heavy clicks -  I've heard rumours that this may be caused if a previous 
owner has modified the rig for faster QSK...  can some kind soul please 
point me at the board/component that I can check for this mod?

Finally here's one to make you chuckle...
Having bought this OMNI D to function as sole rig and knowing it wasn't 
exactly in pristine condition I found the following:    The S meter was 
erratic and the S meter lamp flickered a lot.... some joker had secured a 
tagstrip carrying the supply to the lamp and the S meter lead to the front 
chassis via a rusty 1/2" Wood Screw  - argggggggghhhhhhhhhhhhh.

73  Tony G3ZRJ


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec