|To:||"Richard Arland" <email@example.com>|
|Subject:||Re: [TenTec] Argonaut 509...The Saga Begins|
|From:||Clark Savage Turner <firstname.lastname@example.org>|
|Date:||Sun, 14 Nov 2004 19:51:32 -0800|
I just procured a 509 that was adverstised as "mint". Well, guess what? It wasn't. Surprise, surprise!
I hate when that happens.
Common problem. I've seen it in many of the 509's I've picked up. The dial cord can be off, too. Pain in the butt, but when you get it right, it runs smoothly (Ten Tec has cord and other parts when needed).
The IF board is not what I have become use to in my previous 8 or 9 Argonaut 509s. This board does not have the IF xtal filters on a seperate PCB that plugs piggy-back onto the top of the IF board. No, this one has four IF xtals soldered onto the IF board...strange. Is this an early IF board, perhaps? The s/n of this particular Argo is
Most of my Argo 509's had this board. I had to wire in a separate 4 pole filter to get the 8 pole total, and I got the added benefit of much better stop band attenuation (I think that the board allows a lot of blow by, and I put another 4 pole into the circuit before the first filter, completely curing the blowby as I recall! I would just get another 4 pole, it is cheaper and easier :-)
The RF output is, shall we say, "suspect". Tuning into a dummy load via a WM-2 wattmeter, full scale on the Argo meter with the METER switch in the FWD position should yield about 2.5-3 watts output. It registers 1.3 Watts on the WM2. I can crank the DRIVE control full clockwise and get about 8 watts out of the Argo. This should not happen. I suspect that there are some "spurs" or other garbage on the output of
Not too unusual. I got 5 - 6 watts from several of mine. You might check with Garland at Ten Tec (Charlie, W1HZE mentioned Garland, the right fellow to speak with!!!)
about this, he would know whether it is a problem or not.
The receiver does work, although the RESONATE control is exceptionally "loose" and it tends to roll counter clockwise when tuning bands 14 MHz and higher.
Again, pretty common in the ones I've had. Use more felt washers or add some stiffer grease at the right points. Ten Tec has suggestions on this one, too.
I would not worry, try some ProGold from Caig, or get some DeOxit D-5 from Caig. I would not use run-of-the-mill Tv tuner cleaner, the Caig products will preserve the lube and it is what Ten Tec recommends in the switches.
Let us know how it works out!
_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||Re: [TenTec] Hi power Ten Tec ant tuner swr drift?, Al Scanandoah|
|Next by Date:||Re: [TenTec] Hi power Ten Tec ant tuner swr drift?, Michael Tope|
|Previous by Thread:||[TenTec] Argonaut 509...The Saga Begins, Richard Arland|
|Next by Thread:||Re: [TenTec] Argonaut 509...The Saga Begins, Al Scanandoah|
|Indexes:||[Date] [Thread] [Top] [All Lists]|